EN IS0 11469 EUROPEANSTANDARD NORMEEUROPEENNE EUROPAISCHE NORM October 2016 ICS83.080.01 Supersedes ENIS011469:2000 EnglishVersion Plastics - Generic identification and marking of plastics products (Is0 11469:2016) Plastiques - Identification generique et marquage des Kunststoffe-SortenspezifischeIdentifizierungund produits en matiere plastique (IS0 11469:2016) Kennzeichnung von Kunststoff-Formteilen (ISO 11469:2016) This European Standard was approved by CEN on 17September 2016. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom. cen EUROPEAN COMMITTEE FOR STANDARDIZATION COMITE EUROPEEN DE NORMALISATION EUROPAISCHES KOMITEE FUR NORMUNG CEN-CENELECManagementCentre:AvenueMarnix17,B-1000Brussels @2016CEN All rights of exploitation in any form and by any means reserved Ref.No.ENISO 11469:2016 E worldwide for CEN national Members. ENIS011469:2016 (E) European foreword in collaboration with Technical Committee CEN/TC249"Plastics"the secretariat of which is held by NBN. identical text or by endorsement, at the latest by April 2017, and conflicting national standards shall be withdrawn at the latest by April 2017. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document supersedes EN IS0 11469:2000. According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia France, Germany,Greece,Hungary,Iceland, Ireland, Italy,Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. Endorsementnotice IS0 11469:2016(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normativereferences 3 Terms and definitions 4 Symbols and abbreviated terms. ..2 5 Requirements .2 5.1 Marking system. .2 Marking of products. .2 5.1.1 22 5.1.2 Single-constituent products 5.1.3 Polymerblends or alloys. 5.1.4 Compositions with special additives 3 5.2 Method of marking. 4 @IS0 2016 -All rights reserved ili