ISO INTERNATIONAL STANDARD 10145-2 Second edition 2016-03-01 End mills with brazed helical hardmetal tips - Part 2: Dimensions of end mills with 7/24 taper shank Fraises cylindriques deux tailles dplaquettes helicoidales en metaux- durs,brasees Partie2:Dimensions des fraises a queue cone 7/24 Reference number IS0 10145-2:2016(E) ISO @IS0 2016 IS010145-2:2016(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISo's member body in the country of the requester. ISO copyright office Ch.de Blandonnet 8.CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org ii IS02016-Allrights reserved IS0 10145-2:2016(E) Contents Page Foreword iv 1 Scope 1 2 Normativereferences. .1 3 Dimensions. .1 Annex A (informative) Relationship between designations in this part ofIs0 10145 and IS013399 3 @ IS0 2016 - All rights reserved iii