INTERNATIONAL ISO STANDARD 9747 First edition 2000-12-15 AerospaceDouble-shank ball-ends,in corrosion-resistant steel,swaged on aircraft control wire rope Dimensions and loads Aéronautique et espace-Embouts a sphere centrale,en acier résistant a la corrosion,a sertir sur cables de commande d'aeronefs-Dimensions et charges iso Reference number ISO 9747:2000(E) 4Madrid,Spain (allright 1802:38:43 UTC 2024 Downloaded/printed for Georeia Institute of Technologv.This standard provided by AENOR.No further reproductions authorized 9747:2000(E) ISO PDF disclaimer This PDF file may contain embedded typefaces.ln accordance with Adobe's licensing policy,this fle may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.ln dowrloading this fle,parties accept therein the responsibility of not infringing Adobe's licensing policy.The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. PDF file can be found in the General Info relative to the fle;the F PDF-creation Details of the software products used to create this F parameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by Iso member bodies.ln the ISO 2000 All ights reserved.Unless otherwise specified,no part of his publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfim,without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case_ postale 56-CH-1211 Geneva 20 Tel.+41227490111 Fax +41227490947 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii Downioaded/printed for Georeia Institute of Technologv.This standard provided by AENOR.No further reproductions authorized. 9747:2000(E) c ISO ISO Foreword IsO (the International Organization for Standardization)is a worldwide federation of national standards bodies (isO Commission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives,Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting International Standard ISO 9747 was prepared by Technical Committee ISO/TC 20,Aircraft and space vehicles, Subcommittee SC 12,Mechanical system parts. Annex A forms a normative part of this International Standard. ili reproductions authorized