ISO INTERNATIONAL 2247 STANDARD Third edition 2000-03-01 Packaging Complete, filled transport packages and unit loads Vibration tests at fixed low frequency Emballages - Emballages d'expédition complets et pleins et charges unitairesEssais de vibration abasse fréquence fixe Reference number ISO 2247:2000(E) ISO @ ISO 2000 ISO 2247:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The iso Central Secretariat accepts no liability in this area. Adobe isatrademarkofAdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either SO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland ISO 2247:2000(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 2247 was prepared by Technical Committee ISO/TC 122, Packaging, Subcommittee /SO/TC122) This third edition cancels and replaces the second edition (IsO 2247:1985), which has been technically revised Annex A forms a normative part of this International Standard.