ISO INTERNATIONAL STANDARD 14526-1 First edition 1999-11-15 Plastics Phenolic powder moulding compounds (PF-PMCs)- Part 1: Designation system and basis for specifications Plastiques — Poudres a mouler phénoliques (PF-PMC) - Partie 1: Systeme de désignation et base de spécification Reference number ISO 14526-1:1999(E) A ISO @ ISO 1999 ted without license from IHS Not for Res-ale ISO 14526-1:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @IsO1999-Allrightsreserved ed without license from IHS Not for Res-ale ISO 14526-1:1999(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. InternationalStandardsaredraftedinaccordancewiththerulesgivenintheISO/iECDirectives,Part3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 14526 may be the subject o patent rights. IsO shall not be held responsible for identifying any or all such patent rights. SC 12, Thermosetting materials. ISO 800:1992, of which they constitute a technical revision. IsO 14526 consists of the following parts, under the general title Plastics - Phenolic powder moulding compounds (PF-PMCs): Part 1:Designation system andbasis for specifications —Part 2: Preparation of test specimens and determination of properties -Part3:Requirementsforselectedmouldingcompounds ili aonaOganizaionforsandardzalionserve