ISO INTERNATIONAL 10499-2 STANDARD First edition 1998-07-01 Industrial tyres and rims Rubber solid tyres (metric series) for pneumatic tyre rims - Part 2: Load ratings Pneumatiques et jantes pour materiel de manutention Bandages pleins en caoutchouc (serie millimetrique) pour jantes de pneumatiques - Partie 2: Capacités de charge ISO Reference number ISO 10499-2:1998(E) ISO 10499-2:1998(E) Foreword IsO (the International Organization for Standardization) is a worldwide preparing International Standards is normally carried out through IsO technical committees.Each memberbody interested ina subject for which a technical committee has been established has the right to be represented on that committee.International organizations,governmental and non- governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 10499-2 was prepared by Technical Committee ISO/TC 31, Tyres, rims and valves, Subcommittee SC 7, Industrial tyres and rims. IsO 10499 consists of the following parts, under the general title Industrial tyres and rims Rubber solid tyres (metric series) for pneumatic tyre rims: Part 1: Designation, dimensions and marking Part 2: Load ratings ISO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International Organization forStandardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Internet [email protected] X.400 c=ch; a=400net; p=iso; o=isocs; s=central Printed in Switzerland ii ISO 10499-2:1998(E) INTERNATIONAL STANDARD @ ISO Industrial tyres and rims Rubber solid tyres (metric series) for pneumatic tyre rims - Part 2: Load ratings 1 Scope This part of IsO 10499 specifies the load ratings of the metric series of rubber solid tyres for pneumatic tyre rims primarily intended for industrial vehicles for use on prepared surfaces. ISO3739-3. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard.At the time of publication,the editions indicated were valid.All standards are subject t revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and IsO maintain registers of currently valid International Standards. ISO 3739-3:1995, Industrial tyres and rims Part 3: Rims. ISO 5053:1987, Powered industrial trucks - Terminology. Designation, dimensions and marking. 3 Definitions For the purposes of this part of ISO 10499, the definitions given in ISO 3877-4, ISO 4223-2 and ISO 5053 apply. 4 Tyre designations 4.1 Dimensional and constructional characteristics See ISO 10499-1.