ISO INTERNATIONAL STANDARD 11677-1 First edition 1994-11-15 Textile machinery and accessories - Main dimensions of flat steel healds with open end loops Part 1: C-shaped end loops Materiel pour I'industrie textile -Dimensions principales des lisses en acierplatavec boucles d'extrémités ouvertes Partie1:Bouclesd'extrémitésenformede《C" ISo Reference number ISO 11677-1:1994(E) ISO 11677-1:1994(E) Foreword which a technical committee has been established has the right to be re- presented on that committee. International organizations, governmenta! and non-governmental, in liaison with IsO, aiso take part in the work. sO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Internationai Standard requires approval by at least 75 % of the member bodies casting a vote International Standard ISO 11677-1 was prepared by Technical Committee isO/Tc72,Textilemachineryandalliedmachineryandaccessories,Sub- committee SC 3, Machinery for fabric manufacture. IsO 11677 consists of the following parts, under the general title Textile machineryand accessories ---Main dimensions of flat steelhealds with open end loops: 一 Part 1: C-shaped end loops Part2:J-shapedendloops ISO 1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case Postale 56· CH-1211 Geneve 20· Switzeriand Printed in Switzerland INTERNATIONAL STANDARD ISO ISO 11677-1:1994(E) Textile machinery and accessories Main dimensions of flat steel healds with open end loops - Part 1: C-shaped end loops 1 Scope This part of IsO 11677 specifies the main dimensions and tolerances of flat steel healds with open end loops (C-shaped end loops) for use in the textile industry. cessories --- Main dimensions of flat steel healds with open end loops - Part 2: J-shaped end loops. 2 Dimensions See figure 1 and table 1