ISO INTERNATIONAL STANDARD 11399 First edition 1995-12-15 Ergonomics of the thermal environment Principles and application of relevant International Standards Ergonomie des ambiances thermiques --- Principes et application des Normes internationalespertinentes ISO Reference number ISO 11399:1995(E) Copyright International Organization for Standardization No reproduction or networking permited without license from IHS e with ISC Not for Resale ISO 11399:1995(E) Contents Page 1 Scope 2 Normative references 3 Ergonomics of the thermal environment -- Principles 2 The use of relevant International Standards to assess thermal environments 2 Description of International Standards concerning hot environments 6 Description of International Standards concerning moderate thermal environments Description of International Standard concerning cold environments 8 Description of International Standards concerning skin contact with solid surfaces 9 Description of supporting and complementary International Standards 10 Description of future International Standards 12 Annexes A Ergonomics of the thermal environment - Principles of assessment 13 B Ergonomics of the thermal environment: Future Internationa Standards 17 c Bibliography 19 ?ISO1995 All rights reserved. Uniess otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56 : CH-1211 Geneve 20 : Switzerland Printed in Switzerland ii No reproduction or networking permited without license from IHS Not for Resale ISO IS011399:1995(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO which a technical committee has been established has the right to be and non-governmental, in liaison with isO, also take part in the work. IsO collaborates ciosely with the International Electrotechnical Commission (lEC)onalfmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an international Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 11399 was prepared by Technical Committee ISO/TC 159, Ergonomics, Subcommittee SC 5, Ergonomics of the physi- cal environment. Annexes A, B and C of this International Standard are for information only ili Copyright Intematinal Organizationfor Standardizatin Not for Resale