ISO INTERNATIONAL STANDARD 4254-10 First edition 2009-12-15 Agricultural machinery Safety - Part 10: Rotary tedders and rakes Matérielagricole-Sécurité Partie 10: Faneuses et andaineuses rotatives Reference number A ISO 4254-10:2009(E) ISO @ ISO 2009 ISO 4254-10:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In nn COPYRIGHTPROTECTEDDOCUMENT 9 ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ IO 2009 - All rights reserved ISO 4254-10:2009(E) Contents Page Foreword iv Introductior Scope 2 Normative references 3 Terms and definitions 4 List of significant hazards .. 5 Safety requirements and/or protective measures.... 5.1 General ..... 5.2 Noise.. 5.3 Protection against inadvertent contact with tines and tine arms 5.4 Controls.. 17 5.5 Machinein storageposition.. 19 5.6 Swivellingandmovablecomponentsfortransport .24 5.7 Drawbar hitch and/or carrier frame ............ 25 6 Verification of the safety requirements and/or protective measures . Information for use..... .26 7.1 Instruction handbook... .26 7.2 Marking.... 27 7.3 Safety and instructional signs . .27 Annex A (informative) Tedders and swath rakesExamples. .28 Annex B (normative) Strength test . 3 Annex C (informative) Stability of tractor-rotary tedder and rake combination.. 32 Bibliography... .34 uy @ IS0 2009 - All rights reserved ili